Simple triangle "Vase"
Simple triangle "Vase"
Published 2017-08-16T16:51:26+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
This model is made to take advantage of the vase mode found in many of the popular and widely used 3D printer slicers like cura. Allowing a user to determine the wall thickness of the vase themselves, rather than being stuck with a pre- determined one from me. I did print this using vase mode in cura and I like the results. I don't know much about the VECTARY software, but I like making vases in it and find it easy to do.
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
Depending on if you use vase mode and how thick you set the walls will factor into how long it takes to print. I printed the one above with 3 shells or a 1.2mm wall thickness, because I am using a 0.4mm nozzle.
Date published | 16/08/2017 |
Tecnología | FDM |
Sin apoyo | YES |