Spray can handle/trigger
Spray can handle/trigger
Published 2017-09-01T10:27:14+00:00
I made this at the request of someone from of the many 3d printing facebook groups I am a part of. This is a all in one spraycan handle/trigger. I printed both versions without supports, however the curved model may look a bit bad surface finish wise. The V2 removed the curve and changed the angle of the trigger while being printed. Since this is a pressfit solution I recommend printing out the small pressfit tester first. Just to see if the pressfit will reproduce on your printer. Other problems could include the trigger fusing with the handle. I've not had it happen, but it's possible. You can check out my video below of it in use. https://www.youtube.com/watch?v=IxVCsVSmEsw
I printed without supports, the handle is hollow on the inside to help reduce material ussage on infill. I printed at a 0.2mm layer height and with 3 shells or 1.2mm prerimiters. My infill was only set to 10%
Date published | 01/09/2017 |
Tecnología | FDM |
Complejidad | Muy fácil |
Sin apoyo | YES |