Nintendo Switch Blade
Nintendo Switch Blade
3D
Published 2017-03-14T10:11:40+00:00
This was a quick design I knocked up to make a very low profile stand that I could use in the standard nintendo switch travel case. Something thin but a bit more substancial than the built in kick stand that would also allow for charging in use and make the device lay a little flatter for close tabletop use on plaes for example.
The black one pictured is the first version printed on an Objet 30 pro. But I have since redesigned numerous times for different application (45 or 60 degrees) and for printing on a High Quality printer or a simple FDM machine. The run down of each is thus:
HQ is for high quality/high tolerance printers.
FDM Flat, is the Switch Blade as a print in one unit laid out open with 0.5mm tolerances for the hinge pin and 0.5mm between the alternating hinges.
FDM 1.75 is the Switch Blade as two separate parts, L and R with a hinge bore of 2.3mm for a piece of 1.75mm filament to become the hinge pin.
Then lastly FDM 2.85is the Switch Blade as two separate parts, L and R with a hinge bore of 3.2mm for a piece of 2.85mm filament to become the hinge pin.
| Date published | 14/03/2017 |
| ¿Cuándo tiempo lleva? | 60 - 120 minutos |
| Tecnología | FDM |