Time and Relative Dimension in Space (TARDIS) Light Switch Cover Plate
7,691
visitas
471
descargas
5
colecciones
1 comentarios
Cargando comentarios...
Time and Relative Dimension in Space (TARDIS) Light Switch Cover Plate
3D
Published 2014-12-11T22:18:59+00:00
60
1
Add to Collection
Descripción
You will need to print the ring and the top unit and glue them together. The design allows you to reverse the ring so the super smooth surfaces of the print bed are what should be glued together. I decided to go with the ring design to remove any need for bridging, allowing for a cleaner print. If the switch plate you are using this on is recessed into the wall, you will not need the ring, but I have found most seem to be raised slightly and space is required behind the plate to allow it to set cleanly on the wall.
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 67 g of filament and takes 356 minutes.
Información técnica
Date published | 11/12/2014 |
¿Cuándo tiempo lleva? | 350 - 378 minutos |
Tecnología | FDM |
Complejidad | Muy fácil |
Sin apoyo | YES |
Más información
Archivos
Love this. I printed it in glow in the dark blue PLA.