Triple Ring Snowflake Ornament
2,598
visitas
243
descargas
2
colecciones
0 comentarios
Cargando comentarios...
Triple Ring Snowflake Ornament
3D
Published 2018-12-20T11:30:16+00:00
18
0
Add to Collection
Descripción
This is my second 3D ornament. It is a print-in-place model that does not require supports. The rings should be easy to spin after you remove the print from the print bed, no assembly required! I reworked the hole for the ribbon so it would print better.
Detalles de impresión
Use 0.1 mm layer heights and a 0.4 mm nozzle (standard on most printers). I also used 20% infill, though it does not make a lot of difference on this model since the features are fairly thin to begin with. I recommend using bridge settings to help the axle pins print properly.
Información técnica
Date published | 20/12/2018 |
Dimensiones | 85.0mm X 91.5mm X 6.4mm |
Sin apoyo | YES |
Más información
Archivos