Wheel Chock - 120mm (~4.75 inch)
$2.70 Wheel Chock - 120mm (~4.75 inch)
3D
Published 2019-10-08T13:50:12+00:00
A sturdy scale wheel chock for a medium to large size model aircraft, designed to stabilize the aircraft’s wheels, during transportation and at the field. The chock can be easily 3D printed, without any support, on a modern inexpensive 3D Printer.
This object can be printed with a variety of materials, including PLA, PETG, ABS and other type of printable materials.
PLA works very well for this application. It is easy to print. The wheel chock should be durable, easy to maintain, and last for a long time. However, it should not be stored or kept at high temperature, exceeding ~55 C (~ 130 F).
Should the wheel chock be left in a high temperature environment, such as a parked car in the summer, I strongly recommend using another heat tolerant material, such as PETG or ABS to prevent warping.
4 chocks are required to make a complete set.
They work well to prevent the model from rolling off a table.
* The model aircraft shown in the pictures is a 120cc., 27 lbs (~ 12.2Kg), Aeroworks Ultimate Biplane, courtesy of Troy Emmett.
Recommended print settings with a .4 mm nozzle
- Layer Hight: .150 ~.160 mm, depending on motors and gearing
- 3 perimeters or shells (1.2 ~ 1.5 mm)
- 8 bottom layers (1.2 ~ 1.3 mm)
- 8 top layers (1.2 ~ 1.3 mm)
- Infill 15%~20%, depending on infill type
Assembly
4 chocks are required to make one complete set of 2 chocks assembly.
To make one assembly, use approximately 70 cm (~27 ½”) of small diameter rope, i.e.: 5mm (~3/16"), that fit through the chock’s central hole, to link two chocks together. Tie a knot of sufficient size on each end of the assembly, to prevent the rope from sliding back through the hole. Simple figure 8 knots on each end works well for me.
| Date published | 08/10/2019 |
| Precio | $2.70 |
| ¿Cuándo tiempo lleva? | 210 - 1200 minutos |
| Cantidad de filamento | 47 grams each - 188 grams for a set |
| Dimensiones | 120mm X 40mm X20mm each |
| Sin apoyo | YES |