Z Probe For Micromake D1
4,797
visitas
109
descargas
0 comentarios
Cargando comentarios...
Z Probe For Micromake D1
3D
Published 2017-03-06T11:05:01+00:00
2
0
Add to Collection
Descripción
Z probe for Micromake D1. When calibration is no force on the limit switch. You need only one wire to rewire. I achieved with this method of calibration tolerance of 0.01 mm on a radius of 80 mm The second option is to connect without soldering, it is necessary to invert the signal in the firmware
Información técnica
Date published | 06/03/2017 |
Más información
Archivos