dethham's Print of BULLET BILL / BANZAI BILL
Community Print Impresión 3D de BULLET BILL / BANZAI BILL
Published 2020-03-01T19:55:50+00:00
1
2
Descripción
I'm not sure why this won't work. I got a 50% scale model to print and screw in correctly, but twice now I have tried a 100% scale model and the top piece and bottom do not screw together. I have a small slope to my print on the top, which I think is also impacting the fit? I see many people commented below about threading issues, and others say the threading is perfect. Any suggestions? Printing using Flashforge Adventurer 3 Lite, .12mm layer height, brim, 210 extruder, 100 plate, 40mm/s print speed, 7mm retraction. The red arrows on the image show all around the bottom of the top piece, it does not print directly vertically but seems to have a small taper (like a persons waist) before flaring out a bit. I cannot get the bottom to screw in more than shown on the image-leaves like 3 threads sticking out the bottom of the top piece.