dafa1's Print of Railroad Hand Car and wagon
Community Print Impresión 3D de Railroad Hand Car and wagon
Published 2020-08-29T07:44:42+00:00
0
1
Impreso con: Anycubic i3 Mega
Material: PLA
Descripción
It's great, I'm done.
1. I'm not sure if it is the problem with my printer. In step 3, the M3*12mm used should use M3*14mm screws. The 12mm I used is a bit short.
2. Step 6 Here, the shaft without gears will block the battery, I cut it off, and it does not affect the use
3.Then the M3*20 screw in step 4, there is a possibility that the screw will be tightened when rotating, and then the whole car is not good, I removed the nut, and it looks good.
Now I am printing the tracks. Overall it is great. I like it very much. Thank you for sharing. If you encounter problems in the production process, you can ask me for help.
By the way, my battery uses a 9V square battery. It can be placed in the recessed place.