LTDInvestments's Print of K-9
810
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de K-9
Published 2021-10-04T17:41:00+00:00
1
0
Material: PLA
Descripción
FINALLY finished him..... Wife chose the colors and I had problem printing the body green color. No problem with the model just my filament. Normally I print most of my models @ .16mm but I couldn't get a nice print without layer lines (needed to dry the filament). Tried Prusa Slicer and paint-on supports but for some reason could not get them to work @ .16 or .08. Switched to a newer Cura and was able to add supports around RedDadSteve's builtin supports and was able to get a good print @ .08. I might try this @ 250% @ .2mm to match my BIG Marvin the Martian!
Red - Esun Fire Engine Red
Light Green - WYZworks Flo Green (body)
Middle Green - Hatchbox True Green (ears)
Dark Green - Filacube Green
Yellow - Hatchbox PPLA (I think....)
Gold - Zyltech Gold
Black - Polymaker Charcoal Black Poly Terra (PLA variation)
White - Hatchbox White PPLA