Design8Studio's Print of LARGE Destiny Ghost Fully Detailed Model, LED Illuminated, no supports!
Community Print Impresión 3D de LARGE Destiny Ghost Fully Detailed Model, LED Illuminated, no supports!
Published 2022-12-25T11:34:25+00:00
0
0
Impreso con: BIQU b1
Material: PLA
Descripción
Made this for a gift for a family member. I had to remix to get an 8-sided tea light to fit, and my magnets were too small — not successful at getting them glued in, so I opted to print additional pins, and to drill holes in the main body and the winglets, and just pin and glue the winglets on. Hopefully that did not ruin it. Merry Christmas everyone! PS: the dial was way too tight to spin. Had to sand it down significantly. If I had it to do over I'd remix it too.