Belstone's Print of Blink Fox (multi-material remix)
Destacado
2,304
visitas
0 comentarios
Cargando comentarios...
Community Print Impresión 3D de Blink Fox (multi-material remix)
Published 2018-09-19T10:25:35+00:00
20
0
Impreso con: Wanhao Duplicator i3 PLUS
Material: PLA
Descripción
Hollowed in Fusion 360 and printed at 127% scale. Had to scale eyes, ears, and the U-shaped tail tip down to between 121% and 125% to fit. Chest fit snug but needed a little sanding around the edges. Other tails and nose fit fine at 127%. Haven’t put the ears in yet in the pics. Evenly coated with Septone Acrylic Putty Spray and then lightly sanded for smoothing, then coated with a generic chrome-silver spray paint. Then coated evenly with Tamiya Metallic Purple (for polycarbonates) and then evenly dusted a few times with Tamiya Iridescent Pink-Gold spray paint (also for polycarbonates). Given two coats of Tamiya Clear Semi Gloss (for plastics) for protection and finally an even coat of Tamiya Translucent Pearl (for polycarbonates again). Lately, after these pics were taken, sprayed some Tamiya Translucent Silver (polycarbs again) into a cup and brushed it onto the silver parts to bring back the glint and shine that was dulled by the semi gloss.