Cat Pod Feeder
Cat Pod Feeder
3D
Published 2017-04-28T14:03:43+00:00
This design was printed with with PLA filaments from Meltink3d. Use code: twiesner10 to recieve 10% of your next filament order at Meltink3d.com and print this design today!
__________________________________________
Boredom, frustration, and environmental stress are some of the most common reasons that cats exhibit behavior problems. Encouraging foraging behavior is said to be one of the best things you can do for your cat.
This simple support free 3d print is composed of two pieces: the dome and the bowl. The openings are wide enough for cats to get their paws through to dig out the food but the opening on the top will give the illusion that the cat's head may fit (but can't). When not glued together the dome twists as the cat maneuvers the food pieces out, giving a slight extra layer of challenge.
If your cat is clever enough to tip the dome then it is recommend to glue the bowl to the dome.
Print at 0.3 mm with 15% fill on a printer with a build volume of at least 160 mm x 160 mm x 105 mm
Glue the bottom to the top dome if your feline is clever enought to tip the pod feeder over.
| Date de publication | 28/04/2017 |
| Durée d’impression | 840 - 1020 minutes |
| Quantité de filament | 190 g |
| Dimensions | 154 mm x 154 mm x 102.2 mm |
| Technologie | FDM |
| Sans support | YES |