Nuka Cola - Rocket Girl Plant Pot
Nuka Cola - Rocket Girl Plant Pot
Published 2017-10-17T14:49:46+00:00
Pots & Planters design for the 2017 Autodesk Tinkercad and BQ's Witbox 2 Design Competition.
This object was made in Tinkercad. tinkercad.com/things/cuc4hABVh9Y
Printed at 60% scale. .1618 layer height, 30% infill, 5 top/bottom layers, 3 shells, supports and raft. Printing the Rocket, you can print the rocket however you desire, but I was unhappy with the quality printing it as one solid object. I tried several orientations, and they all seemed to cause flaws on the model, there is very little surface area that it prints with if you print it as one object, you either run into issues on the fins or on the tip if you print it vertically. My solution was to use Ideamaker to cut this model in half, and print it in two parts. Much better quality, with only a little seam which could easily be fixed. The base also has an issue if you using simplify3d, it will print but you will end up with base not being attached totally to the bottom. The solution for this is to use "seperate connected surfaces" and it will print fine. I ran the model through Cura, and it will print fine without any modification.
Date de publication | 17/10/2017 |
Durée d’impression | 700 - 1200 minutes |
Quantité de filament | 150g @ 60% scale |
Dimensions | n/a |
Technologie | FDM |
Complexité | Medium |