Turnip Head!
Turnip Head!
3D
Published 2017-02-15T11:32:36+00:00
Turnip Head, from the wonderful movie Howl's Moving Castle. If you have not seen it, I highly recommend you do so. The model is an easy enough print with no supports needed.
I've set it up for two print beds. One measures 170.03 x 88.04 x 93.16. The second measures 79.95 x 91.48 x 98.05.
I've also included the full model and the parts.
The model measure around 30 cm tall when assembled. Reduce at your own risk:P
Arms and pipe
I used heat to soften the arm joint before gluing them together.
I've taken his pipe and put it inside of his hat. It should just snap off. I had no problem printing it but it is really, really small. I've included a small hole in Turnip Heads left side mouth for placement.
The only areas that required an extra bit of sanding was his chin and the bow-tie.
| Date de publication | 15/02/2017 |
| Dimensions | 100, 214, 300 |
| Technologie | FDM |
| Complexité | Medium |
Easy to print, I only converted the stick and the base