3DPN Spool Holder of Awesomeness D1
3DPN Spool Holder of Awesomeness D1
Published 2018-07-20T17:53:48+00:00
This design was intended to fill the need of whatever size spool you have or need to hold. I have included the F3D file (fusion 360 native file) so that you can take full advantage of the parameters I've used to model it:
-Spool ID Hole Dia
-Spool OD diameter
-Distance above or below the mount to the wood (ZSpoolDist)
-How far the spool sits away from the wood of the shelf (XSpoolDist) so the spool doesn't rub the shelf!
-The width of the spool being used (Spoolwidth) to make sure the round part that holds the spool is long enough.
I printed this in PETG, but since I do not have a stress tester, I have no idea the maximum limit of the holder.
I have also modeled a little knob that will retain whatever spool you end up putting on the holder (so that it doesn't all come tumbling down)
Date published | 20/07/2018 |
Support Free | YES |