Folding Rack-mount Spool Holder
Folding Rack-mount Spool Holder
3D
Published 2018-08-10T16:15:30+00:00
It took a while. This thing was one of the biggest prints I've done. But then again, I'm printing with an MP Select Mini. The setup is easy and the pictures do it justice. If you put the spool on so that the filament comes out towards the rack then you will get slightly better un-spooling. File down any smooshed bottom layers. I did print the Twist-clip and it works, but then I glued the Upper and lower halves together.
I had some problems getting Videos to be on my SD :/ They'll be here soon!
Happy printing!
Print at 20-25% infill and 3 shells. I was holding whole kilos of metal filament and with no problems. If the Complete-Holder doesn't fit on your printer, print the Upper- and Lower-Holder and glue them. that's what I did. If you don't have glue print the Twist-clip and put that on as well, but boost the strength on the clip. but don't expect to hold 1+ kilos of filament with the twisty clip.
| Date published | 10/08/2018 |
| Technology | FDM |
| Complexity | Easy |