Be careful, i print my designs on my Creality CR10, so maybe the print parameters could change. I used Ultimaker Cura for all the config.
For all the prints i used the triangles infill.
the telephone booth, the base and the top has a 20% Infill and 7% of grid supports. I highly recommend to use a brim plate adhesion to prevent buckling.
I recommend printing the base upside down
for letters and posters i used 100% infill and obviusly without any supports.
I bought the light in Ikea
I will upload a video soon!!!!!!!!
I hope this parameters help you to build this amazing table lamp. enjoy it!
Any Question you can just coment or sent my a message. Peace