This object was entered in the MakeShaper Design Challenge (see all entries here).

Not very long after purchasing my Moto 360 Sport smart watch I realized that the band began to tear apart. I immediatly googled to see if I could purchase a replacement band. To my dismay, there were no replacements available for purchase. I took to SolidWorks, and modeled this watch band off measurements of the the smart watch. The band has print in place hinges that allow the watch band to fit around the wrist better. The smart watch is held inplace by the material, and the clasp is reused from the original band. I have been using this watch band every day for the past 2 months and it is showing no signs of wear. The overall length of the watch band is 9.85in, so it should fit most people.