Hello,

this is a simple and easy-to-build enclosure for the Original Prusa i3 MK3. It is fixed on the printer so that it is easily portable. All the parts are easy to print - that means: support is almost not needed. There also is a detailed PDF instruction. A list of parts can be found below. You can use the Multi Material Upgrade 2.0 because 5 Spools of filament can be held. I was not able to print it or test it because I am not a Prusa owner (yet;) ). But it should work. Use this design for the cables of your bed:  https://www.thingiverse.com/thing:2837970

Thanks for watching and if you print it: have a nice print!

Yours sincerely,

Simon

Part list:

• ~150 m4 hammer nuts (can also be printed)
• ~150 m4x10mm screws
• ~25   m4x16mm screws
• ~20   m4 nuts
•   6     m4 washers
•    4    anything with a diameter of 3mm and a lengh of          100mm (m3 threaded rod,...)
• all      3D printed parts
• 1x     16mm x 510mm pipe (better metall)
• eventually ground plate 490mm x 460mm
• or 4x  foam (90mm x 90mm x 15mm or bigger)

   aluminium extrusions (2020 with >/=5mm groove)

• 4x      499mm
• 4x      459mm
• 4x      489mm
• 2x      459mm

   plexiglass: use 5mm 

• 2x      250mm x 459mm
• 2x      494mm x 470mm
• 1x      500mm x 459mm
• 1x      500mm x 470mm