Resistor Tester Stand
Resistor Tester Stand
Published 2017-04-13T10:33:57+00:00
I modified the Solder Cable holder from user landin81. I edited the design in Tinkercad and then used wire to make metal inserts to connect to the resistor. A set of connectors are on the front to plug in an ohm meter. The wire inserts are then soldered to the connectors.
The connectors I used were in my mixture of electronics components that I removed from old equipment. I don't know where to get replacements but these will probably work as a substitute. You may have to resize the holes.
http://amzn.to/29Snfci
The wire used for the metal insert connections was just 14 gauge household electrical wire that was flattened on the end and then a groove cut in them.
The full design can be seen at my YouTube channel at:
Date published | 13/04/2017 |
Technology | FDM |
Complexity | Easy |