Rey's Staff
Rey's Staff
3D
Published 2019-08-10T17:50:11+00:00
I made a model of Rey's Staff after wanting to make her staff for a while before I had my printer. This whole model is based around a 21.5mm diameter pipe I had so when printing keep that in mind.
The model consists of 29 pieces, each piece has notched on the inside hole at the bottom of them to show which piece they are bar part 1 which has it in its top (these may be clearer to see on different printers but came out countable on mine).
Some of the pieces in the middle (mainly 11 through 16) can be omitted to lengthen to your needs and if you want to save on filament as these are slightly thicker than the pipe to gage spacing, each are a good guide for where to wrap each material after printing.
A good number of pieces need supports to print correctly but if printing vertically I would suggest that pieces 8, 10, 17, 18, 19, and 23 only have support touching the build plate
Piece 1 is the base piece (I think it's not always consistent in pictures which end is the top), so I would build up from there in piece number order, the notches are a helpful guide post-print as to the order but you can always refer back to the files if needed.
My print was done on a Anycubic i3 Mega, with a 0.2mm layer height, varying supports, and in the Silk Grey PLA by Stronghero 3D.
Happy Printing and Cosplaying.
| Date published | 10/08/2019 |