Use "The Force" to Open your PC :D

This 3d printed Stormtrooper Open/Close PC button is made to replace the hole (58mm) from the desk from where the cables are puted. 

The 3d prinde object have (100mm High), and the insert hole (D=58mm) 

For this project you will need :

1) 2 Springs (it works even if you dont use them)
2) 1 normal push button with a head

3) some thin electric cable.

4) Superglue.

The pin will be attached to the motherboard power pin.

It dose not matter in wich way you put the pins.