wayzezowski
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×wayzezowski
I created this cover/decoration for the Wyze Competition.
I decided to create this cover to go with a monster inc. Mike Wazowski theme.
Designed with main camera cover as one piece with little or no need for supports. Includes a opening for usb plug on the rear side.
Depending on your printer, support may be needed for openings. I would use tree supports and print the whole design on a 45 degree angle. I have not printed this one yet.
I would print this using PLA at .16 or .2 layer height.
Infill 20% to 100%
Depending on your printer, support may be needed for openings. I used tree supports and printed the whole design on a 45 degree angle.
Status | Rejected |
Time to do | 374 - 375 minutes |
Material Quantity | 55g |
Dimensions | 65.4mm x 78mm x 57mm |