Pipe Revolver - Fallout 4
Pipe Revolver - Fallout 4
Published 2018-05-29T13:59:04+00:00
Ready to go adventuring into the wasteland? Take this handy pistol along with you to fend off radroaches and not much else.
WARNING Orilo's armoury takes no responsibility for character death if challenging Deathclaws, Supermutants, the Brotherhood of Steel, Synths, Mercenaries, Gunners, Raiders, Mole Rats or other dangerous creatures.
This was modeled in Fusion 360 with reference photos taken from Fallout 4.
It is broken into 17 pieces that can be assembled with the adhesive of your choice as well as a complete model that can be used as a guide for assembly. I couldn't get the cylinder pin support to combine with the full gun but it just hooks underneath the thin part of the cylinder pin and the top bit it sandwiched between the barrel and main support.
Hope you have fun printing this. :)
Dimensions is to print the single largest part (the handle) in x and y, with z being the tallest part standing on end (the bottom barrel) of the individual parts. Printed in clear Colorfabb XT, and various PETG at layer height of .1618 at 10% infill
Date de publication | 29/05/2018 |
Durée d’impression | 1400 - 1600 minutes |
Quantité de filament | 226g |
Dimensions | 101x162x143 |
Technologie | FDM |
Complexité | Easy |
Dimensions is to print the single largest part (the handle) in x and y, with z being the tallest part standing on end (the bottom barrel) of the individual parts. Printed in clear Colorfabb XT, and various PETG at layer height of .1618 at 10% infill