DaveRigDesign's Print of COVID-19 MASK
Community Print Impression 3D de COVID-19 MASK
Published 2020-04-12T04:56:05+00:00
1
1
Description
Really like this design. I found the nuts didn't fit on the thread the 1st time but scaling up the cap and collar nut up 1% universally in Simplyfy 3d fixed the problem. I also added some rubber weather stripping, it really adds to the comfort and makes a better seal.One question, how many filters are supposed to go in the short tube? With just 1 filter and the 2 grates it is too loose. I may look into added a 1 way valve for exhaust, with that I think it will be perfect. Great job