mattia1's Print of Seradon Starmaster
539
views
0 comments
Loading comments... 
Community Print 3D Print of Seradon Starmaster
Published 2021-12-14T18:09:08+00:00
0
0
Printed on: Anycubic Photon S
Material: Resin
Description
Seradon only. Looks great and the scale is spot on, no need to resize. Able to fit seradon, rider, and stand all on one build plate but almost no room left. Will say to be careful removing supports as 2 claws and the right wing tip broke while I was doing so, but experience may vary with settings/resin. Only with it would come in smaller parts, might reduce print time/support removal. Still, glad to have purchased!
Room Temp- 75F 20%humidity
Resin - Elegoo Clear Blue Water Washable
Settings - 6/burn in layers; 18s/exposure; .035mm/layer height; 5s/light off delay; 9s/exposure time; 4.5mm/lift after print; 115mm/m/lifting speed; 150mm/m/lowering speed.
~19.5hr printing time
Cleaned by letting soak in "mean green" cleaning product, with supports. Makes support removal a lot easier. Rinsed in clean water after support removal. Final cure under UV lamp ~5-10min.